Currency Displayed in
● 101L FORGED CONNECTING ROD / 15-PIN (15 X 35 X 101)
● Custom length stroke-up forged connecting rod (101L) to be used with high performance and racing applications.
This connecting rod can be used in combination with big pistons, or forged pistons which are typically much heavier compared to cast pistons.
● The distance from center to center is 101mm (101L), the big-end inner diameter is 35mm, the small-end diameter is 15mm!...
This forged connecting rod can be installed on any HONDA 125 and 150 "PCX" crankshaft type, Scomadi TL/TT125i, Lambretta V125, GY6 QMI125 / QMJ150 crankshafts, YAMAHA 115, 115i and T135 / T-150 crankshaft types, etc...
If you install this connecting rod then keep in mind that this connecting rod need to be used in combination with a 15mm piston pin piston!
※Installing this 101L conrod on the STD stroke crankshaft would make really good power, 1.74 RATIO which is perfect!
Your cylinder head would breath better because your piston spend more time at top dead center, and you could make your piston also shorter/lighter then...
OPTIONAL:
- Ø28X35X14MM BIG END NEEDLE BEARING (LINK)
- SPL Ø28X35X14MM BIG END NEEDLE BEARING (FOR OFFSET STROKER PINS) (LINK)
※ The forged connecting rods can not be installed with the stock/standard Honda Ø28 x 36 x 14mm needle bearings!...
● These are the stroke-up connecting rods lengths we have available for your crankshaft type:
HONDA:
● This connecting rod is mentioned to be installed on these 150 crankshafts:
● This connecting rod can also be installed on these 125 crankshafts:
YAMAHA:
LAMBRETTA:
ROYAL ALLOY:
SCOMADI:
※ Keep in mind that you need to install additionally a piston with a 15mm piston pin in combination with this connecting rod!
※ This connecting rod can not be installed on the new YAMAHA VVA 155 engine types such as YZF-R15 VVA (Version 3) and 155 VIXION R / FZ155i!...
All prices are in THB